Tracker 2WD L4-1.6L VIN 6 (2000)
Steering Gear: Service and Repair
Power Steering Gear Pipe/Hose Replacement - Inlet
Power Steering Gear Inlet Pipe
Removal Procedure
Important: The power steering gear inlet pipe connects the power steering gear to the power steering gear inlet hose.
1. Use a siphon in order to remove the power steering fluid from the reservoir (6).
Notice: Refer to Power Steering Hose Disconnected Notice in Cautions and Notices.
Important: Place a drain pan under the vehicle in order to catch any escaping fluid.
2. Remove the power steering gear inlet pipe fitting (5) from the steering gear.
3. Remove the power steering gear inlet pipe and the 2 gaskets from the steering gear.
4. Remove the power steering gear inlet pipe from the power steering gear inlet hose.
Power Steering Gear Inlet Pipe
Installation Procedure
Notice: Refer to Fastener Notice in Cautions and Notices.
1. Install the power steering gear inlet pipe to the power steering gear inlet hose.
-
Tighten the power steering gear inlet hose to the power steering gear inlet pipe connection to 40 Nm (29 ft. lbs.).
Notice: Refer to Installing Hoses Without Twists or Bends Notice in Cautions and Notices.
