Tracker 2WD L4-1.6L VIN 6 (2000)
2. Install the power steering gear inlet pipe (6) and the 2 gaskets to the steering gear. Secure the pipe to the gear with the pipe fitting (5).
-
Tighten the fitting to 35 Nm (25.5 ft. lbs.).
Notice: Refer to Using Proper Power Steering Fluid When Adding Notice in Cautions and Notices.
3. Add power steering fluid to the reservoir. Refer to Checking and Adding Power Steering Fluid.
Notice: Refer to Air In The Steering System Notice in Cautions and Notices.
4. Bleed the power steering system. Refer to Bleeding Power Steering System.
Power Steering Gear Inlet Hose
Removal Procedure
Important: The power steering gear inlet hose connects the power steering gear inlet pipe to the power steering pump.
1. Use a siphon in order to remove the power steering fluid from the reservoir (6).
Notice: Refer to Power Steering Hose Disconnected Notice in Cautions and Notices.
Important: Place a drain pan under the vehicle in order to catch any escaping fluid.
2. Remove the power steering gear inlet hose fitting from the power steering pump.
3. Remove the power steering gear inlet hose and the 2 gaskets from the power steering pump.
4. Remove the power steering gear inlet hose from the power steering gear inlet pipe.
Power Steering Gear Inlet Hose
Installation Procedure
Notice: Refer to Fastener Notice in Cautions and Notices.
Notice: Refer to Installing Hoses Without Twists or Bends Notice in Cautions and Notices.
