Tracker 2WD L4-1.6L VIN 6 (2000)
Rear Knuckle Alignment Link: Service and Repair
Installation Procedure
Important: DO NOT tighten the bolts. The weight of the vehicle must be on the tires and wheels before tightening the bolts.
1. Install the following components to the rear axle and to the vehicle body: The rear axle tie rod (2) The 2 washers The 2 bolts (1,3) The nut
2. Lower the vehicle.
Notice: Refer to Fastener Notice in Cautions and Notices.
3. With the weight of the vehicle on the tires and wheels, tighten the bolts (1,3).
-
Tighten the bolts to 90 Nm (65.0 ft. lbs.).
