Tracker 2WD L4-1.6L VIN 6 (2000)
5. If the vehicle has ABS, remove the wheel speed sensor clamps (2) from the upper control arm (1) and the axle housing.
6. Remove the E-ring from the right rear brake pipe.
7. Disconnect the breather hose from the axle housing.
8. Lower the rear axle housing gradually as far down as necessary in order to remove the coil spring (2).
Installation Procedure
Important: When seating the coil spring, mate the spring end with the stepped part (4) of the rear axle spring seat (3).
1. Install the coil spring (1) on the spring seat (3) of the axle housing (2). Raise the axle housing.
Important: DO NOT tighten the nuts and bolts. The weight of the vehicle must be on the tires and wheels before tightening the nuts and bolts.
