Tracker 2WD L4-1.6L VIN 6 (2000)
Suspension Travel Bumper: Service and Repair
Front Suspension
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
3. Remove the coil spring. Refer to Front Coil Springs Replacement.
4. Remove the spring rubber seat (1).
5. Remove the bump stopper (3).
Installation Procedure
Notice: Refer to Fastener Notice in Cautions and Notices.
1. Install the bump stopper (3).
-
Tighten the bump stopper to 50 Nm (36.5 ft. lbs.).
2. Install the spring rubber seat (1).
3. Install the coil spring. Refer to Front Coil Springs Replacement.
4. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
5. Lower the vehicle.
