Tracker 2WD L4-1.6L VIN 6 (2000)
Wheel Bearing: Service and Repair
Front Wheel Bearing Replacement
Removal Procedure
FRONT WHEEL BEARING/HUB
-
Tools Required
-
J8092 Driver Handle
-
J37772 Front Wheel Bearing Race Remover
-
J37763 Front Wheel Bearing Lock Nut Remover
-
J6627-A Wheel Stud Remover
Important: If you are removing the hub in order to gain access to other components, you may remove the hub, the bearings, and the seals together as
a unit.
1. Remove the 4 screws (1) and the seal lock washer retainer (2).
2. Raise and support the vehicle. Refer to Vehicle Lifting.
3. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
4. Remove the brake rotor. Refer to Brake Rotor Replacement in Disc Brakes.
5. Remove the cap from the spindle.
6. Use the J37763 in order to remove the front wheel bearing lock nut (2).
7. Remove the washer and the outer wheel bearings.
8. Remove the hub with the inner wheel bearings and the oil seals.
Important: If you are replacing the hub, the bearings, or the seals, continue with this procedure.
9. If the vehicle has ABS, remove the wheel speed sensor ring from the hub. Refer to Wheel Speed Sensor Ring Replacement-Front in Antilock
Brake System.
