chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Liftgate Window Glass|Service and Repair|Page 10107 > < Window Run Channel Replacement - Front Door|Page 10103
Page 1
background image

Liftgate Window Glass: Service and Repair

Rear Window Replacement

Removal Procedure

Tools Required

*

J 24402-A Glass Sealant Remover (Cold Knife)

*

J 39032 Stationary Glass Removal Tool

*

Isopropyl alcohol or equivalent 

*

Cartridge-type caulking gun

*

Commercial-type utility knife

*

Razor blade scraper

*

Suction cups

*

Plastic Paddle

1. Apply masking tape to the area around the rear door window in order to protect the painted surfaces from damage.
2. Remove the spare tire and wheel assembly from the spare wheel carrier. Refer to Spare Tire Replacement.
3. Gently disengage the plastic retainers which secure the rear door hinge cover (1).
4. Remove the rear door hinge cover (1) from the vehicle.
5. Remove the rear window wiper arm, if equipped. Refer to Rear Window Wiper Arm Replacement.
6. Disconnect the rear window defogger electrical connectors.
7. Remove the rear door window reveal molding.

1. Grasp the lower corner of the rear door window reveal molding by hand and slowly pull the reveal molding away from the rear door window.
2. If the rear door window reveal molding will not release, use a utility knife in order to cut around the rear door window in order to remove the

reveal molding.

Caution:  Refer to Glass and Sheet Metal Handling Caution in Cautions and Notices.

Important:  Keep the cutting edge of the tool against the rear window when removing the rear window. This will allow the urethane
adhesive to be separated from the rear window. Leave a base of urethane on the pinchweld flange. The only suitable lubrication is clear
water.

8. Use the J 24402-A  (1) or J 39032  in order to cut the rear door window (2) from the pinchweld flange.
9. Gently unseat the rear door window retainer-male ends on the window from the rear door window retainer-female ends on the door.

10. With the aid of an assistant, use the suction cups in order to lift the rear door window from the opening.
11. Inspect the following components for the causes of a broken rear window:

*

The flange of the rear window opening

*

The rear window reveal molding

*

The rear window

Liftgate Window Glass|Service and Repair|Page 10107 > < Window Run Channel Replacement - Front Door|Page 10103