Tracker 2WD L4-2.0L VIN C (1999)
Brake Shoe: Service and Repair
REMOVAL PROCEDURE
CAUTION: Avoid taking the following actions when you service wheel brake parts:
^
Do not grind brake linings.
^
Do not sand brake linings.
^
Do not clean wheel brake parts with a dry brush or with compressed air.
Some models or aftermarket brake parts may contain asbestos fibers which can become airborne in dust. Breathing dust with asbestos fibers may cause
serious bodily harm. Use a water-dampened cloth in order to remove any dust on brake parts. Equipment is available commercially in order to perform
this washing function. These wet methods prevent fibers from becoming airborne.
1. Raise and support the vehicle.
2. Remove the tire and wheel assembly.
3. Remove the brake drum.
4. Turn the shoe hold down pins (1) in order to release the shoe hold down springs (2).
5. Remove the shoe hold down springs.
6. Remove the following components:
^
The upper return spring (1)
^
The strut
^
The adjuster (2)
^
The adjuster lever
^
The adjuster spring (5)
^
The strut spring (3)
^
The pawl lever (6)
7. Remove the lower return spring (4)
