Tracker 2WD L4-2.0L VIN C (1999)
3. Place the J 39567 on the master cylinder (1).
4. Push the J 39567 pin down until it touches the master cylinder piston (2).
5. Remove the J 39567 from the master cylinder.
6. Turn the J 39567 upside down and set it on the booster assembly (1).
Specification
The clearance (2) between the booster piston rod (3) and the J 39567 should be 0 mm (0 inch).
7. If the measurement does not equal the specification, use the J 37767 in order to hold the booster piston rod (1).
8. Turn the adjusting screw of the piston rod in order to adjust the clearance.
INSTALLATION PROCEDURE
