Tracker 2WD L4-2.0L VIN C (1999)
3. Apply GM P/N 12346240 or equivalent to the cylinder head at the points indicated (1).
4. Install the 4 new O-rings (3) to the cylinder head cover (1).
5. Install the new cylinder head cover gasket (2) to the cylinder head cover.
6. Install the new cylinder head side seal (4) to the cylinder head.
7. Install the cylinder head cover to the cylinder head.
Notice: Refer to Fastener Notice in Service Precautions.
8. Install new washers to the cylinder head cover and install the cap nuts.
Starting in the center, cross-tighten the cylinder head cover nuts evenly to 11 Nm (97 inch lbs.).
9. Install the 4 ignition coils (1).
10. Connect the 4 ignition coils.
11. Install the accelerator cable to the clip on the cylinder head cover.
