Tracker 2WD L4-2.0L VIN C (1999)
Drive Belt Tensioner: Service and Repair
Drive Belt Tensioner Replacement (Accessory)
Removal Procedure
Caution: Refer to Battery Disconnect Caution in Service Precautions.
1. Disconnect the negative battery cable.
2. Remove the accessory drive belt.
3. Remove the 2 drive belt tensioner bolts.
4. Remove the drive belt tensioner (2).
Installation Procedure
1. Install the drive belt tensioner (2).
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the drive belt tensioner bolts.
Tighten the 2 tensioner bolts to 25 Nm (19 ft. lbs.).
3. Install the accessory drive belt.
4. Connect the negative battery cable.
Tighten the bolt to 15 Nm (11 ft. lbs.).