Tracker 2WD L4-2.0L VIN C (1999)
1. Install the condenser fan to the condenser. Secure with the 4 nuts (3).
NOTE: Refer to Fastener Notice in Cautions and Notices.
2. Install the condenser with the fan to the vehicle and secure with the 4 mounting bolts.
Tighten
Tighten the condenser mounting bolts to 20 N.m (15 lb ft).
3. Install new O-rings lubricated with mineral base 525 Viscosity refrigerant oil to the condenser fittings.
4. Connect the condenser outlet tube (6).
Tighten
Tighten the condenser outlet tube fitting to 35 N.m (26 lb ft).