Tracker 2WD L4-2.0L VIN C (1999)
Transmission Position Switch/Sensor: Service and Repair
Removal Procedure
Caution: Refer to Battery Disconnect Caution in Service Precautions.
1. Disconnect the negative battery cable (1).
2. Remove the cooler lines.
3. Remove 1 electrical connector from the transmission range switch (1).
4. Remove the following components from the manual shaft:
^
The 1 nut
^
The 1 washer
^
The manual lever with cable attached
5. Unstake the lock plate behind the manual shaft nut.
6. Remove the manual shaft nut and the lock plate from the transmission range switch.
7. Remove 1 bolt and the transmission range switch from the manual shaft.
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.
