Tracker 2WD L4-2.0L VIN C (1999)
Oxygen Sensor: Description and Operation
Heated Oxygen Sensor 2 (HO2S 2)
Heated Oxygen Sensor 2 (HO2S 2)
A Three-way Catalytic Converter (TWC) is used in order to control the emissions of Hydrocarbons (HC), Carbon Monoxide (CO), and Oxides Of
Nitrogen (NOx). The catalyst within the converter promotes a chemical reaction which oxidizes the HC and CO present in the exhaust gas. The catalyst
converts the HC and CO into harmless water vapor and carbon dioxide. The catalyst also reduces NOx by converting the NOx to nitrogen. The
Powertrain Control Module (PCM) uses the HO2S 2 in order to monitor the oxygen storage capability of the catalytic converter. The HO2S 2 reacts to
the oxygen content in the exhaust stream after it passes through the catalytic converter. The voltage signal created by the HO2S 2 sensor ranges from
approximately 0.1 volt (high oxygen - lean mixture) to 0.9 volt (low oxygen - rich mixture). The oxygen sensor heater is required for the catalyst monitor
HO2S 2 in order to become active and begin accurate catalyst monitoring. An HO2S 2 signal that appears lazy or inactive is normal. The PCM compares
readings from both the HO2S 1 and the HO2S 2 in order to determine the efficiency of the catalyst in the TWC converter.
In order for the HO2S 2 to function properly, it must have clean reference air provided to it. This clean reference air is obtained through the oxygen
sensor pigtail wiring. Any attempt to repair the wires, the connectors, or the terminals of the HO2S 2 pigtail wiring could result in the obstruction of the
reference air. Replace the oxygen sensor if the pigtail wiring, the connector or the terminals are damaged.
