Tracker 2WD L4-2.0L VIN C (1999)
4. Unstake the lock washer (2).
5. Remove the inner tie rod (1) from the rack (3).
INSTALLATION PROCEDURE
NOTICE: Refer to Fastener Notice in Service Precautions.
1. Install a new lock washer (2) and inner tie rod (1) to the rack.
-
Tighten the inner tie rod to 85 Nm (61.5 ft. lbs.).
2. Stake the lock washer at the flat spots on the inner tie rod.
3. Install the boot (3). Refer to Rack and Pinion Boot Replacement - On Vehicle.
4. Install the outer tie rod. Refer to Tie Rod End Replacement - Outer - On Vehicle.
5. Lower the vehicle.