Tracker 2WD L4-2.0L VIN C (1999)
7. Inspect the outer tie rod ball joint. Replace the outer tie rod end (7), if necessary.
INSTALLATION PROCEDURE
1. Install the tie rod lock nut (3) to the match mark on the inner tie rod (1). Do NOT tighten the lock nut.
2. Install the outer tie rod end (7) to the inner tie rod (1).
NOTICE: Refer to Fastener Notice in Service Precautions.
IMPORTANT: When tightening the outer tie rod nut, support and push the outer tie rod end with a jack in order to prevent the ball stud from
rotating.
3. Install the outer tie rod end (7) to the knuckle (5), and install the outer tie rod nut (4).
-
Tighten the nut to 43 Nm (31.5 ft. lbs.).
4. Install the tire and wheel assembly.
