Tracker 2WD L4-2.0L VIN C (1999)
4. Remove the key from the ignition switch.
NOTICE: The steering column must be in the LOCK position before disconnecting the following components:
-
The steering column
-
The steering shaft coupling
-
The intermediate shaft
-
The lower steering shaft
After disconnecting these components, do not move the front tires and wheels. Failure to follow these procedures may cause improper alignment
of some components during installation and result in possible damage to the SIR coil.
5. Turn the steering wheel to the left in order to lock the steering column and allow access to the steering shaft coupling bolts (4,5).
6. Remove the bolt (1) on the lower steering shaft side of the steering shaft coupling.
7. Loosen the bolt (3) on the steering column side of the steering shaft coupling.
8. Use a plastic hammer in order to tap the steering shaft coupling (5) onto the steering column shaft, releasing the lower steering shaft.
9. Secure the coupling on the steering column shaft with the the bolt (3).
