Tracker 2WD L4-2.0L VIN C (1999)
1. Align the serrations in the wheel bolts (2) with the serrations in the bolt holes. Use a hydraulic press (1) in order to install the 5 wheel bolts.
2. If the vehicle has ABS, install the wheel speed sensor ring. Refer to Wheel Speed Sensor Ring Replacement - Front in Antilock Brake System.
3. Use the J 37777 and a hydraulic press in order to install the bearing race (1) to the hub (2). Press-fit the bearing race until the end of the race
contacts the stepped surface of the wheel hub.
4. Apply wheel bearing lubricant, GM P/N 1051344, or the equivalent, to the inner bearings (2).
5. Install the inner bearings (2) into the wheel hub (3).
6. Install the snap ring retainer (1).
IMPORTANT: Apply lubricant to more than 60 percent of the vacant space of the hollow of the bearing seal.
7. Apply wheel bearing lubricant, GM P/N 1051344, or the equivalent, to the lip portion and to the hollow of the bearing seals.
