Tracker 2WD L4-2.0L VIN C (1999)
4. Install the clutch pedal return spring to the brake pedal bracket.
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the clutch pedal shaft arm (17) onto the clutch pedal shaft aligning index marks made during removal; secure with 1 bolt and 1 nut.
^
Tighten the clutch pedal shaft arm bolt and nut to 24 Nm (17 ft. lbs.).
Installation Procedure
1. Apply Lubriplate Lubricant, GM P/N 1052196, or equivalent, to the clutch pedal pull back spring (18).
2. Install the clutch pedal assembly into the vehicle.
3. Install the 4 nuts at the bottom of the clutch pedal bracket.
^
Tighten the 4 nuts to 33 Nm (24 ft. lbs.).
4. Install the 3 bolts (25) at the top of the clutch pedal bracket.
^
Tighten the 3 bolts to 33 Nm (24 ft. lbs.).
5. Install the brake pedal push rod clevis pin and retainer.
6. Install the clutch master cylinder push rod clevis pin and retainer.
7. Connect the release clutch pedal position switch (22).
8. Connect the stoplamp switch.
9. Connect the manual transmission clutch start switch (24).
