Tracker 4WD V6-2.5L VIN 4 (2001)
Front Bumper Cover / Fascia: Service and Repair
Front Bumper Fascia Replacement
Removal Procedure
1. Remove the headlamps. Refer to Headlamp Replacement.
2. Remove the front side marker lamps. Refer to Front Side Marker Lamp Replacement.
3. Remove the 7 plastic retainers along the top which secure the front bumper fascia.
4. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.
5. Remove the bolt (1) and the plastic retainer (3) which secure the front bumper fascia (2) at each side.
6. Remove the 3 bolts (2) which secure the front bumper fascia (1) along the bottom.
7. Slide forward and remove the front bumper fascia (1) from the vehicle.
Installation Procedure
Notice: Refer to Fastener Notice in Cautions and Notices.
1. Install the front bumper fascia (1) to the vehicle. Ensure that the front side marker lamps wiring harness is routed into position. Secure the fascia
with the 3 bolts (2) along the bottom.
Tighten the front bumper fascia bolts to 15 N.m (11 lb ft).