Tracker 4WD V6-2.5L VIN 4 (2001)
4. Install the 2 bolts which secure the lower hinge to the door (3). Do not tighten fully at this time.
NOTE: Refer to Fastener Notice in Service Precautions.
5. Install the 2 bolts (2) which secure the upper hinge (4) to the door (3).
Tighten
^
Tighten the rear side door hinge bolts to 27 N.m (19 lb ft).
^
Tighten the rear side door upper hinge nut to 23 N.m (17 lb ft).
6. Install the lower center pillar trim.
7. Remove the floor jack (1) and the piece of wood.
8. Close the front side door.
9. Adjust the rear side door lock striker (2) vertical measurement in order to align with the center of the rear side door lock (1).
10. Keep the lock striker (2) level while moving the striker sideways in order to adjust the rear side door flushness with the quarter panel, as needed.
Refer to Door Adjustment Specifications.
