Tracker 4WD V6-2.5L VIN 4 (2001)
8. Remove the rear seat recliner front mounting bolt (3) from each side of the seat back cushion (1).
9. Remove the seat back cushion (1) from the vehicle.
Installation Procedure
1. Install the rear seat back cushion (1) to the vehicle. Secure the cushion with the rear seat recliner front mounting bolt (3) at each side. Do not
tighten fully at this time.
Notice: Refer to Fastener Notice in Cautions and Notices.
2. Install the rear seat recliner rear mounting bolts (2).
Tighten the rear seat recliner mounting bolts to 35 N.m (25 lb ft).
3. Lower the seat cushion.
4. Pull up on the rear seat back cushion latch release knobs. Fold the rear seat back cushion forward.
