Tracker 4WD V6-2.5L VIN 4 (2001)
2. Install the BPMV (4) and the EBCM (1) as an assembly to the lower mounting bracket (3).
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the bolt that connects the EBCM/BPMV assembly to the lower mounting bracket (3).
Tighten the bolt that connects the BPMV (4) to the lower mounting bracket (3) to 10 Nm (7 ft. lbs.).
Caution: Make sure brake pipes are correctly connected to brake pressure modulator valve. If brake pipes are switched by mistake, wheel
lockup will occur and personal injury may result. The only two ways this condition can be detected are by using a Scan Tool or by doing an
Antilock stop. Important: If a new BPMV is being installed, remove the shipping plugs from the valve openings during the next few steps
when ready.
4. Install the master cylinder brake pipes to the BPMV (1).
Tighten the master cylinder brake pipe fittings to 24 Nm (18 ft. lbs.).
5. Install the wheel cylinder brake pipes to the BPMV (1).
Tighten the wheel cylinder brake pipe fittings to 24 Nm (18 ft. lbs.).
