Tracker 4WD V6-2.5L VIN 4 (2001)
Brake Shoe: Service and Repair
Brake Shoe Replacement
Removal Procedure
Caution: Avoid taking the following actions when you service wheel brake parts:
^
Do not grind brake linings.
^
Do not sand brake linings.
^
Do not clean wheel brake parts with a dry brush or with compressed air.
Some models or aftermarket brake parts may contain asbestos fibers which can become airborne in dust. Breathing dust with asbestos fibers
may cause serious bodily harm. Use a water-dampened cloth in order to remove any dust on brake parts. Equipment is available
commercially in order to perform this washing function. These wet methods prevent fibers from becoming airborne.
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel assembly.
3. Remove the brake drum. Refer to Brake Drum Replacement.
4. Turn the shoe hold down pins (1) in order to release the shoe hold down springs (2).
5. Remove the shoe hold down springs.
6. Remove the following components:
^
The upper return spring (1)
^
The strut
^
The adjuster (2)
^
The adjuster lever
^
The adjuster spring (5)
^
The strut spring (3)
^
The pawl lever (6)
7. Remove the lower return spring (4)
