Tracker 4WD V6-2.5L VIN 4 (2001)
10. Remove the 5 screws and the insulation from the evaporator case.
11. Separate the evaporator case halves (4).
12. Remove the evaporator from the lower case.
13. Remove the expansion valve (1) from the evaporator by removing the 2 bolts.
14. Remove the evaporator temperature sensor (3) from the evaporator.
INSTALLATION PROCEDURE
1. Install the evaporator to the lower case.
2. Install the evaporator temperature sensor (3) to the evaporator.
3. Install the expansion valve (1) to the evaporator. Secure with the 2 bolts.
4. Connect the evaporator case halves (4). Secure the case halves with the 5 screws.
5. Install the evaporator case to the vehicle.
NOTE: Refer to Fastener Notice in Service Precautions.
6. Install the 5 screws and 2 nuts (1).