Tracker 4WD V6-2.5L VIN 4 (2001)
9. Remove the nut from the center of the bulkhead on the engine side (1).
10. Remove the 2 nuts from the heater case (2).
11. Separate the floor ducts from the heater case.
12. Remove the heater case from the vehicle.
DISASSEMBLY PROCEDURE
1. Remove the 8 retaining clips from the heater case.
2. Remove the screw and the blend door linkages.
3. Separate the heater case halves.
4. Remove and replace the following components as necessary:
^
The defrost switch (1)
^
The blend doors (3)
^
The heater core (2)
^
The linkages
ASSEMBLY PROCEDURE