Tracker 4WD V6-2.5L VIN 4 (2001)
Crankshaft Position Sensor: Service and Repair
CRANKSHAFT POSITION (CKP) SENSOR REPLACEMENT
REMOVAL PROCEDURE
1. Disconnect the electrical connector from the Crankshaft Position (CKP) sensor.
2. Remove the bolt (1) and the sensor wire harness clip from the engine.
3. Remove the bolt (3) securing the CKP sensor to the engine.
4. Remove the CKP sensor (3) and the wire harness from the engine.
5. Inspect the CKP sensor signal rotor for damaged or missing teeth through the CKP sensor opening.
INSTALLATION PROCEDURE
NOTE: Do not pinch or damage the CKP sensor wire harness between the engine block and transmission during the transmission installation.
Observe that the CKP sensor wire harness remains properly located in the channel provided at the rear of the engine block during the installation.