Tracker 4WD V6-2.5L VIN 4 (2001)
approaches that of the pre-catalyst oxygen sensor, the catalyst efficiency is degraded.
Stepped or staged testing levels allow the PCM to statistically filter test information. This prevents falsely passing or falsely failing the catalyst monitor
oxygen storage capacity test. The calculations performed by the on-board diagnostic system are very complex. Post-catalyst oxygen sensor activity
should not be used to determine oxygen storage capacity unless directed.
A two stage test is used to monitor the catalyst efficiency. Failure of the first stage of the test will indicate that the catalyst requires further testing in
order to determine the catalyst efficiency. The second stage test looks at the inputs from the pre-catalyst and post-catalyst HO2S more closely in order to
determine if the catalyst is actually degraded. This two stage test further increases the accuracy of the oxygen storage capacity monitor. Failing the first
stage test DOES NOT indicate a failed catalyst. The catalyst may be marginal or the fuel sulfur content may be very high.
After-market HO2S characteristics may be significantly different from the original equipment manufacturer HO2S. An inferior HO2S may lead to a false
pass or a false fail of the catalyst monitor diagnostic. An after-market catalytic converter that does not contain the same amount of cerium as the original
catalytic converter can cause a false DTC to set. An incorrect amount of cerium in the catalyst can alter the correlation between the oxygen storage and
the conversion efficiency of the TWC.
Catalyst Monitor (Good Catalyst)
Catalyst Monitor (Good Catalyst)
A good TWC catalyst will show a very active output voltage on the pre-catalyst heated oxygen sensor (1). A good catalyst, 95 percent hydrocarbon
conversion, will show a relatively flat output voltage on the post-catalyst heated oxygen sensor (2).
Catalyst Monitor (Bad Catalyst)
Catalyst Monitor (Bad Catalyst)
