Tracker 4WD V6-2.5L VIN 4 (2001)
Camshaft Position (CMP) Sensor
1. Install HO2S1 (1) to the exhaust manifold with the J 29533-A/BT-8127, J 39194-B, or an equivalent.
Tighten
Tighten HO2S sensor to 45 N.m (32 lb ft).
2. Connect the HO2S 1 electrical connector (1).
HO2S BANK 2 SENSOR 1
NOTE: Refer to Heated Oxygen and Oxygen Sensor Notice in Service Precautions.
Removal Procedure
IMPORTANT: The Heated Oxygen Sensor (HO2S) may be difficult to remove at temperatures of more than 48°C (120°F). In order to prevent
damage to any threads in the exhaust manifold, allow the exhaust system to cool down before attempting to remove the HO2S.
1. Disconnect the HO2S 1 electrical connector.
2. Remove the HO2S 1(2) from the exhaust manifold (1) with the J 29533-A/BT-8127, J 39194-B, or an equivalent.
Installation Procedure
NOTE: Refer to Component Fastener Tightening Notice in Service Precautions.
IMPORTANT: The new HO2S 1 comes with an antiseize coating on the sensor threads. Take precautions in order to prevent the removal of any of
