Tracker 4WD V6-2.5L VIN 4 (2001)
Fuel Supply Line: Service and Repair
FUEL HOSE/PIPES ASSEMBLY REPLACEMENT
REMOVAL PROCEDURE
1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure.
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
2. Disconnect the negative battery cable.
3. Disconnect the fuel vapor hose (3) from the fuel vapor pipe at the engine compartment.
4. Disconnect the fuel return hose (4) from the fuel return pipe at the engine compartment.
5. Disconnect the fuel feed hose (1) from the fuel feed pipe at the engine compartment.
6. Disconnect the retaining clamp (2) from the fuel pipes.
CAUTION: Refer to Vehicle Lifting Caution in Service Precautions.
7. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
8. Disconnect the fuel return hose (1) from the fuel return pipe by the fuel tank.
9. Disconnect the fuel vapor hose (2) from the fuel vapor pipe by the fuel tank.
10. Disconnect the fuel feed outlet hose from the fuel filter.
11. Disconnect the retaining clamps that secure the fuel pipes to the vehicle chassis.
12. Remove the fuel tank.
13. Remove the EVAP canister.
14. Remove the upper control arm from the right side of the rear suspension. Refer to Rear Axle Upper Control Arm Replacement in Rear Suspension.
15. Disconnect the front driveshaft from the front differential.
16. Remove the two post catalyst oxygen sensors. Refer to Heated Oxygen Sensor (HO2S) 2 Replacement.
17. Remove the front exhaust pipe.
18. Support the transmission with a transmission lack.
19. Remove the crossmember that supports the transmission.
20. Remove the fuel lines.
