Tracker 4WD V6-2.5L VIN 4 (2001)
3. Align the offset coupling (1) of the CMP sensor (2) in order to correctly engage the drive slot in the end of the camshaft.
4. Install the CMP sensor housing into the cylinder, while observing the offset coupling on the CMP sensor for proper alignment during installation.
5. Install the CMP sensor housing bolts (3), but do not tighten the bolts.
6. Rotate the CMP sensor housing (2) until the scribed alignment marks are matched up.
NOTE: Refer to Fastener Notice in Service Precautions.
7. Tighten the CMP sensor housing bolts.
Tighten
Tighten the bolts to 15 N.m (11 lb ft).
8. Connect the CMP sensor electrical connector (1).
9. Install a timing light and check the ignition timing. Refer to Ignition System Timing Adjustment Procedure.