Tracker 4WD V6-2.5L VIN 4 (2001)
Manifold Absolute Pressure (MAP) Sensor: Service and Repair
MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR REPLACEMENT
REMOVAL PROCEDURE
1. Disconnect the electrical connector (4) from the MAP sensor (1).
2. Remove the 2 MAP sensor attaching bolts (1).
3. Remove the MAP sensor (2) from the intake plenum.
INSTALLATION PROCEDURE
1. Lubricate the seal on the MAP sensor vacuum port with clean engine oil.
2. Install the MAP sensor (2) into the intake plenum.
NOTE: Refer to Fastener Notice in Service Precautions.
