Tracker 4WD V6-2.5L VIN 4 (2001)
21.
Apply about half of the grease (1) remaining in the small bag to the leading edge of the internal cam (2) inside the opening (3). The remaining
grease in the small bag will not be used.
22.
Turn the ignition key to the ON position.
23.
Place the new assembled AT cover on the lock cylinder housing ensuring that the spring does not fall inside the lock cylinder housing.
24.
Using a small hammer and punch, push the spring pin located in the two retaining tabs into the lock cylinder housing until they are flush with the
top of the tabs.
25.
Install the new AT lever on the lock cylinder the same way the original lever was before being removed earlier in this procedure.
26.
With the ignition key in either the ON or ACCESSORY position, by hand, move the AT lever in (1) and out (3) of the slot (2) in the AT cover.
Verify that it moves freely in and out of the AC cover slot at least 5 times.
27.
Install the ignition switch lock cylinder on the steering column.
28.
Install the three phillips head screws that attach the ignition switch lock cylinder housing to the turn signal switch assembly.
29.
Install the two new bolts included in the kit that attach the ignition switch lock cylinder to the steering column. Continue tightening the bolts until
the heads break off.
30.
Position the transmission park lock cable housing on the ignition switch lock cylinder and install the phillips head screw.
Tighten
Tighten the screw to 2.2 N.m (19.5 lb in).
31.
Connect the park lock cable to the AT lever.
