Tracker 4WD V6-2.5L VIN 4 (2001)
1. Install the starter motor assembly with the pinion towards the front of the vehicle through the area between the exhaust pipe and the transmission.
2. Rotate the starting motor 180 degrees so the pinion faces the back of the vehicle.
3. Move the starting motor toward the front of the vehicle into the engine mount bracket until the pinion clears the transmission case.
4. Move the starting motor towards the back of the vehicle into the transmission case and align the mounting holes.
NOTE: Refer to Fastener Notice in Service Precautions.
5. Install the mounting bolts (1).
Tighten
Tighten the starter motor mounting bolts to 11 N.m (22 lb ft).
6. Connect the positive battery cable to the starter solenoid. Secure with the nut.
Tighten
Tighten the starter solenoid nut to 10 N.m (89 lb in).
7. Connect the starter solenoid electrical connector.
8. Install the bolt (1) to the transmission fluid line bracket.
9. Install the front exhaust pipe to the vehicle.
10. Install the propeller shaft to the vehicle.
11. Secure the front stabilizer shaft to the vehicle with the 4 bolts.
Tighten
Tighten the stabilizer shaft insulator bracket bolts to 15 N.m (11 lb ft).
