Tracker 4WD V6-2.5L VIN 4 (2001)
3. Install the power steering gear inlet hose (4), the 2 gaskets, and the fitting to the power steering pump.
-
Tighten the fitting to 60 Nm (43.5 ft. lbs.).
4. Install the power steering fluid reservoir (1) with the reservoir outlet hose (2) to the vehicle. Refer to Remote Power Steering Fluid Reservoir
Replacement.
5. Install the outlet hose to the power steering pump. Install the hose clamp in order to retain the hose to the pump.
6. Install the power steering pump drive belt. Refer to Drive Belt Replacement - Air Conditioning Compressor and Power Steering in Engine.
Notice: Refer to Using Proper Power Steering Fluid Notice in Service Precautions.
7. Add power steering fluid to the reservoir. Refer to Checking and Adding Power Steering Fluid,
Notice: Refer to Air In The Steering System Notice in Service Precautions.
8. Bleed the power steering system. Refer to Bleeding the Power Steering System.
