Tracker 4WD V6-2.5L VIN 4 (2001)
Wheel Fastener: Service and Repair
Front
Wheel Stud Replacement (4WD)
Tools Required
-
J 6627-A Wheel Stud Remover
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
3. Remove the brake rotor. Refer to Brake Rotor Replacement in Brakes and Traction Control.
4. Remove the hub with the bearings and the seals. Refer to Wheel Hub, Bearing, and Seal Replacement.
5. If the vehicle has ABS, remove the wheel speed sensor ring from the hub. Refer to Wheel Speed Sensor Ring Replacement - Front in Brakes and
Traction Control.
6. Use the J 6627-A in order to remove the 5 wheel bolts from the hub (1).
Installation Procedure
1. Align the serrations in the wheel bolts (2) with the serrations in the bolt holes. Use a hydraulic press (1) in order to install the 5 wheel bolts.
2. If the vehicle has ABS, install the wheel speed sensor ring. Refer to Wheel Speed Sensor Ring Replacement - Front in Brakes and Traction
Control.
3. Install the hub, the bearings, and the seals. Refer to Wheel Hub, Bearing, and Seal Replacement.
4. Install the brake rotor. Refer to Brake Rotor Replacement in Brakes and Traction Control.
5. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
6. Lower the vehicle.