Tracker 4WD V6-2.5L VIN 4 (2001)
Clutch Slave Cylinder: Service and Repair
Clutch Actuator Cylinder Replacement
Removal Procedure
1. Raise and Suitably support the vehicle. Refer to Vehicle Lifting.
2. Drain the hydraulic system.
3. Remove the clutch fluid hose bolt and the washer from the clutch fluid hose.
4. Remove the clutch actuator cylinder bolts (1) from the clutch actuator cylinder.
5. Remove the clutch actuator cylinder (1) from the transmission.
Installation Procedure
1. Before installing the clutch actuator cylinder to the transmission apply a small amount of grease to the tip of the clutch actuator cylinder. Use
lubricant GM P/N 1051344, or equivalent.
2. Install the clutch actuator cylinder to the transmission.
Notice: Refer to Fastener Notice in Service Precautions.
