Tracker 4WD V6-2.5L VIN 4 (2001)
8. Clean the grease and dirt from the flywheel outer surfaces using a suitable solvent.
Installation Procedure
1. Align the flywheel-to-engine marks and install the flywheel (3) to the crankshaft.
Notice: Do not apply an excessive amount of sealant to the flywheel retaining bolt threads. Applying too much sealant will result in the sealant
overflowing the bolt seat. This could cause the bolt to break loose during vehicle operation.
2. Apply GM P/N 12345493, or the equivalent, to the flywheel retaining bolt threads.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the flywheel retaining bolts to the crankshaft. Use the J 35271 to lock the flywheel.
Cross tighten the 8 flywheel retaining bolts to 70 Nm (50.5 ft. lbs.).
4. Install the transmission assembly.
