Tracker 4WD V6-2.5L VIN 4 (2001)
Shifter Transfer Case: Service and Repair
Shift Lever Replacement-On Vehicle
1. Remove the 2 screws, the 2 plastic retainers and the rear console box from the floor.
2. Remove the 2 screws, the 2 plastic retainers and the front console box from the floor.
3. Remove the 1 screw and the gearshift control lever knob (1) from the gearshift control lever.
4. Remove the 6 screws, the boot cover and the gearshift control lever boot (1) from the gearshift control lever.
5. Remove the 1 clamp and the gearshift lever case boot from the gear shift lever case.
6. Remove the gearshift control lever (1) from the gearshift lever case (2) by pushing down on the gearshift control lever pivot (3) and turning
counterclockwise 90 degrees (1/4 turn) and lifting up.
7. Inspect the gearshift control lever for distortion or excessive wear. Replace as necessary.
8. Inspect the gearshift control lever boot and the gearshift lever case cover boot for tears or other damage. Replace as necessary.
Installation Procedure
1. Install the gearshift control lever into the gearshift lever case by pushing down on the shift control lever pivot and turning clockwise 90 degrees
(1/4 turn) and releasing.
2. Install the gearshift lever case boot to the gearshift lever case. Secure the boot with the 1 clamp.