TrailBlazer 2WD L6-4.2L VIN S (2003)
and Accessories).
Condition
Some customers may comment that the front fascia is wavy under the grille or under the front turn signals. Refer to the illustration above.
Correction
1.
Remove the front fascia. Refer to the Fascia Replacement procedure in the Bumpers sub-section of the Service Manual.
2.
Remove the impact bar from the front fascia.
3.
Remove the hot melt on the top of the impact bar.
4.
Clean and scuff the impact bar with a scotch bright pad.
5.
Apply a coating of GM Adhesion Promoter, P/N 12378462 (Canadian P/N 10953554), to the top surface of the impact bar and let dry.
6.
Install 3M Dual Lock, P/N 06463, to the impact bar as shown in the illustration above.
7.
Clean the fascia and apply the Adhesion Promoter to the fascia.
8.
Install the impact bar to the fascia.
9.
Install the front fascia. Refer to the Fascia Replacement procedure in the Bumpers sub-section of the Service Manual.
Parts Information
Warranty Information
