TrailBlazer 2WD L6-4.2L VIN S (2003)
3.
Using the line from the china marker (4) as a guide and starting at the sill plate, install the seal along the rear rocker panel with seal bulb (2)
toward the door. Flatten the bulb and align it to the china marker line pressing lightly.
4.
Close the door and check for the gasket pushing out between the door and the body.
5.
If the gasket was pushing out, realign the gasket in that area.
6.
Trim the gasket so that it does not extend higher than the rocker panel (5) as necessary.
7.
When the gasket is located, open the door and firmly press the gasket into place. A roller tool may be helpful in seating the gasket.
8.
Check the door latch for proper operation:
8.1.
Open the rear door.
8.2.
Open the rear side closure.
8.3.
Listen for two audible clicks while rotating the fork bolt from the full open to the fully latched position.
9.
If two distinct audible clicks are NOT heard:
