TrailBlazer 2WD L6-4.2L VIN S (2003)
Console: Service and Repair
Bracket Replacement - Console Floor
Bracket Replacement - Console Floor
Removal Procedure
1. Block the wheels to prevent the vehicle from moving.
2. Remove the floor shift control knob.
3. Remove the center console. Console Replacement
4. Disconnect the automatic transmission range selector cable.
5. Disconnect the electrical connector from the automatic transmission shift interlock solenoid.
6. Disconnect the electrical connector from the park brake.
7. Remove the console bracket from the vehicle, by removing the retaining nuts (1) from the center instrument panel (IP) bracket.
8. Remove the forward retaining screw, if equipped.
9. Remove the remaining fasteners from the console bracket.
10. Remove the console bracket from the vehicle.
11. Remove the floor shift control.
Installation Procedure
1. Install the floor shift control.
2. Install the console bracket to the vehicle.
3. Loosely install all the fasteners that retain the console bracket to the vehicle.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the retaining nuts (1) to the center IP bracket.
Tighten nuts to 10 N.m (88 lb in).
5. Install the remaining fasteners that retain the console bracket to the vehicle.
Tighten the nuts to 25 N.m (18 lb ft).
6. Connect the electrical connector to the park brake.
7. Connect the electrical connector to the automatic transmission shift interlock solenoid.
8. Connect the automatic transmission range selector cable.
9. Install the center console. Console Replacement
10. Install the floor shift control knob.
11. Remove the wheel blocks from the vehicle.
