TrailBlazer 2WD L6-4.2L VIN S (2003)
Tighten
Tighten the screws to 1.9 N.m (17 lb in).
3. Install the air outlet duct to the console.
4. Install the screw to the air outlet duct.
Tighten
Tighten the screw to 1.9 N.m (17 lb in).
5. Install the console.
Mode Actuator Auxiliary
MODE ACTUATOR REPLACEMENT - AUXILIARY
REMOVAL PROCEDURE
1. Remove the right rear quarter trim panel.
2. Disconnect the electrical connector from the mode actuator-auxiliary (1).
3. Remove the mode actuator-auxiliary (1) from the HVAC module-auxiliary.
4. Remove the retaining screws from the mode actuator-auxiliary.
INSTALLATION PROCEDURE
1. Install the mode actuator (1) to the HVAC module-auxiliary.
2. Install the screws to the mode actuator-auxiliary.
NOTE: Refer to Fastener Notice in Service Precautions.
See: Service Precautions/Vehicle Damage Warnings
