TrailBlazer 2WD L6-4.2L VIN S (2003)
Power Door Lock Switch: Procedures
Switch Replacement - Door Lock and Side Window - Driver
SWITCH REPLACEMENT - DOOR LOCK AND SIDE WINDOW - DRIVER
REMOVAL PROCEDURE
1. Lift up on the front edge of the switch panel in order to release the front retaining clip.
2. Lift up on the rear edge of the switch panel in order to release the 2 rear retaining clips.
3. If equipped, disconnect the electrical connectors from the driver door module (1).
4. If replacing only the driver door module, remove the module from the door trim panel.
5. Disconnect the remaining electrical connectors from the switch panel.
6. If replacing only the switch panel, retain the driver door module for transfer.
7. Remove the switch panel assembly from the vehicle
INSTALLATION PROCEDURE
1. Install the driver door module (1) to the door trim panel.
2. Connect the electrical connector to the driver door module.
3. If replacing the switch panel, connect the remaining electrical connectors.
4. If replacing the driver door module, program the driver door module. Refer to Service Programming System (SPS) (Remote Procedure)Service
Programming System (SPS) (Pass-Thru Procedure)Service Programming System (SPS) (Off Board Remote Procedure)Service Programming
System (SPS) (Off Board Pass-Thru Procedure) in Programming and Personalization Description and Operation in Personalization.
IMPORTANT: When replacing the driver door module, the set up procedure must be performed.
5. Install the switch panel to the door trim panel, ensuring the front and rear retaining clips are fully seated.
