TrailBlazer 2WD L6-4.2L VIN S (2003)
4. Install the lower control arm to lower control am, bracket mounting bolts.
Notice: Refer to Fastener Notice in Service Precautions.
Important: Ensure that the lower control arm is parallel to the lower control arm bracket during the installation and tightening of the lower control
arm mounting bolts and nuts. This will ensure correct alignment of the lower control arm bushings.
5. Install the lower control arm to lower control arm bracket mounting nuts.
Tighten the nuts to 110 Nm (81 ft. lbs.).
6. Connect the shock module yoke to the lower control arm.
7. Install the shock module yoke lower mounting nut.
Important: There is a washer between the stabilizer shaft link and the lower control arm made of herded steel and has a felt inner liner. Only replace
this washer with an identical washer, standard washers should not be used.
8. Install the stabilizer shaft link and washer to the lower control arm.
9. Install the stabilizer shaft link retaining nut.
Tighten the nut to 100 Nm (74 ft. lbs.).
