TrailBlazer 2WD V8-5.3L (2007)
Notice: Refer to Fastener Notice.
4. Install the shock module upper retaining nuts.
Tighten the shock module upper retaining nuts to 45 N.m (33 lb ft).
5. Raise the vehicle.
6. Install the shock module yoke to lower control arm retaining nut.
Tighten the shock module yoke to lower control arm retaining nut to 110 N.m (81 lb ft).
7. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation.
8. Lower the vehicle.
Shock, Shock Component, and/or Spring Replacement
Shock, Shock Component, and/or Spring Replacement
Tools Required
J 45400 Strut Spring Compressor
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation.
3. Remove the shock module from the vehicle. Refer to Shock Module Replacement.
