TrailBlazer 2WD V8-6.0L VIN H (2006)
Caution: In order to avoid personal injury or vehicle damage when you repair or replace the carpet, use the same thickness and material
size as the original installation. Always return the carpet to the original location.
1. Position the carpet to the floor panel.
2. Raise the rear portion of the floor console bracket and slide the carpet underneath the console bracket.
3. Position the rear carpet over the edge of the front carpet.
4. Align the holes in the carpet to the seat studs on the floor panel.
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the four nuts (2) retaining the rear of the floor console bracket to the floor weld studs.
Tighten the nuts to 25 N.m (18 lb ft).
6. Feed the bussed electrical center base and the communication interface module electrical connectors through the pass through holes in the carpet.
7. Install the floor console.
8. Install the center pillar trim panels.
9. Install the front side door sill plates.
10. Pass the communication interface module electrical connectors through the small hole in the carpet.
11. Pass the body electrical block electrical connectors through the small hole in the carpet.
12. Install the body electrical block
13. Install the carpet ensuring that the carpet hooks over the left wheelhouse panel stud.
