TrailBlazer 2WD V8-6.0L VIN H (2006)
Power Seat Control Module: Recalls
Campaign - Driver's Seat Module Programming
Subject:
Product Enhancement for Inventory and Customer Vehicles - Drivers Seat Module Reprogram-Expires with Base Warranty
# 06022 - (03/23/2006)
Models:
2006 Buick Rainier
2006 Chevrolet TrailBlazer, TrailBlazer EXT
2006 GMC Envoy, Envoy XL
2006 Saab 9-7X
with Memory Seats (RPO AAB/YC5/YC6) and OnStar(R) (RPO UEI)
THIS PRODUCT ENHANCEMENT INCLUDES VEHICLES IN DEALER INVENTORY AND CUSTOMER VEHICLES THAT RETURN FOR
ANY TYPE OF SERVICE, AND WILL EXPIRE AT THE END OF THE INVOLVED VEHICLE'S NEW VEHICLE LIMITED WARRANTY
PERIOD.
Purpose
This bulletin provides a service procedure to reprogram the driver's seat module on certain 2006 Buick Rainier; Chevrolet TrailBlazer and TrailBlazer
EXT; GMC Envoy and Envoy XL, and Saab 9 7X vehicles equipped with memory seats (RPO AAB/YC5/YC6) and OnStar(R) (RPO UE1). On rare
occasions, at vehicle start-up, these vehicles may have an extended bulb check and the XM Satellite Radio may take a few seconds longer to activate.
The heated seats, door locks, and power windows may also be inoperative until the key is removed from the ignition.
This reprogramming should be completed as soon as possible on involved vehicles currently in dealership/retailer inventory and customer vehicles that
return to the dealer/retailer for any type of service during the New Vehicle Limited Warranty coverage period.
Vehicles Involved
Service Procedure
Notice:
Before reprogramming, please check the battery condition to prevent a reprogram error of the driver's seat module due to battery discharge. Battery
voltage must be between 12 and 16 volts during reprogramming. If the vehicle battery is not fully charged, use jumper cables from an additional
battery. Be sure to turn off or disable any system that may put a load on the battery such as automatic headlamps, daytime running lamps, interior
lights, heating, ventilation, and air conditioning (HVAC) system, radio, engine cooling fan, etc. A programming failure or control module damage
