TrailBlazer 2WD V8-6.0L VIN H (2006)
11. Install the SIR electrical harness (2) to the seat pan.
12. Install the front/rear J strips (2,4).
13. Install the side J strips (1,3).
14. Install the seat pan to the seat adjuster frame.
15. Install the 4 retaining nuts to the studs on the underside of the cushion.
Tighten the nuts to 25 N.m (18 lb ft).
16. Install the 3 seat switch bezel screws.
Seat Cushion Cover and Pad Replacement - Rear No. 2
Seat Cushion Cover and Pad Replacement - Rear No. 2
Removal Procedure
1. Remove the two bolts (2) securing the rear seat cushion assembly (1) to the seat latch rod (3).
2. Remove the rear seat cushion assembly.
3. Remove the pull handle assembly (1).
4. Remove the J-strips (2) securing the rear seat cushion cover to the seat cushion panel.
5. Remove the seat cushion panel from the pad and cover.
