TrailBlazer 2WD V8-6.0L VIN H (2006)
1. If necessary, install the wave washer (1).
2. Align the block tooth on the steering shaft assembly (1) to the 12 o'clock position.
3. If installing the existing inflatable restraint steering wheel module coil, the coil must be centered first. Refer to Inflatable Restraint Steering Wheel
Module Coil Centering in Steering Wheel and Column.
IMPORTANT: A new inflatable restraint steering wheel module coil is pre-centered. Do not remove the centering tab from the new inflatable
restraint steering wheel module coil until installation is complete.
4. Align the inflatable restraint steering wheel module coil (2) with the horn tower sticking through the shaft lock or cam orientation plate (1).
5. Slide the steering wheel module coil (2) onto the steering shaft assembly.
6. Remove and discard the centering tab from the coil.
7. Install the retaining ring (1) using snap ring pliers.
IMPORTANT: The retaining ring (1) must seat securely on the groove of the race and upper shaft assembly (2).
8. If the steering wheel has PAD control, install the wire harness assembly.
